Home
GM-210/GR-212/GR-213 Support
What's the difference between GM-210 USB & GM210 Universal GPS(Bundle with USB Cable for PC)?

They are the same GPS Receive - GM-210 & same interface - USB.
GM-210 universal GPS(Bundle with USB Cable for PC) can add-in other GM-210 connector cable for Dell,  Sony, Palm,
Toshiba, Hp ...   PDAs, but GM-210 USB can not.
How can I know the GPS unit is receiving the signal?

If the GPS green light is blinking, that means the GPS is working and receiving the signal.
Do I need to install driver for GM-210.

For Pocket PC or Palm PDA, you don’t need to install any driver for them.  What you do is  plug the connector of GM-
210/GR-212/GR-213 cable to the bottom of your PDA, and the GPS signal will transfer to your PDA directly.  The
exceptions are Toshiba e330/e740, you will need to install the driver on the CD or download the latest version from
our website.
For Laptop or notebook, you don’t need to install driver if you are using GM-210/GR212/GR-213 with DB9 (RS-232)
connector.  However, you do need to install the driver on the CD or our website if you are using GM-210 with USB
connector.
I connected USB connector of Y cable to my PC, but it cannot be recognized even if loaded USB driver from your
website, what should I do?

Actually, Y cable is only for PDA device, Y cable cannot communicate with PC even though Y cable has USB connector.
 If you want to connect GM-210/GR-212/GR-213 to PC, you have to buy the
specific USB cable from us.
I have connected Y cable for PDA & GPS correctly , but how should I do next  for GPS utility ?

First, you have to install a testing software such as our GPSViewer or other navigation software, and then it will receive
GPS signal to fix your current position.
Which navigator software can be used?

There is no specific software that is required to use GM-210/GR-212/GR-213.  They work very well with any navigation
software which can accept NMEA0183 output.
How should I configure the setting of GM-210 in navigator software?

NEMA0183 & Baudrate 4800
I have set up the navigation software, but GPS cannot fix at all even though I saw the LED of GM-210 is constantly
on.

Please make sure you place GPS outdoor without any obstruction as the fact that GPS cannot fix position indoor.  
Please note that GPS cannot fix position in dashboard either if your window is tinted as the tinted window will block the
satellite signals.
I bought one GM-210 few months ago and it worked very well until this couple of days. Could you tell me what
happened?

Please do the following steps to evaluate if it has any problem.
1. Install GPSViewer to your device (Please load it from our website)
2. Select correct com port & designate the baud rate at 4800.
3. Open GPS & press “Cold start”  
Sometime GPS have to be executed the “cold start” function to re-acquire satellites if GPS was not used either for long
distance or over long period of time.
I place GM-210 on dashboard and open sky, however, the GPS strength is very low.

Please note that GPS reception might be low if your car window id tinted.
What do I do to place GM-210/GR-212/GR-231 out of my car ?

You can directly place GM-210/GR-212/GR-213 on the car roof by magnet since they are waterproof.
Do you have GM-210/GR-212/GR-213 connection cable for Dell X30?

A. Yes, it is the same cable as X3/X3i, please just up-side-down the cable’s connector to plug into X30.  It will work.
Do you have GM-210/GR-212/GR-213 connection cable for iPaq1900  Series?

A. No, iPaq1900 series can not communicate with other peripherals since they are slave to slave. They are not
supported by GM-210. It is advised to go for GR-231/ GPSlim236 blue tooth GPS.
I have installed the USB driver to my laptop but the device is not detected by my laptop.   What should I do?

The driver might not be installed properly, please do the following steps for evaluation:
1. Un-install and re-install the USB driver again.
2. Connect GM-210/GR-212/GR-213 and your laptop
3. Go to My computer > Properties > Hardware > Device Manager > COM & LPT to see if you can see
GM-210/GR-212/GR-213 on the list.
If you are not sure which com port is GM-210/GR-212/GR-213, you can unplug and plug again to find out the correct port.
I recently bought your GM-210/GR-212/GR-213 to use with my laptop, and my OS is MAC system. Do you have USB
driver for MAC system?

Yes, We have.  
Actually, we have the USB driver for not only windows system, but also MAC & LINUX system.  
How can I enable WAAS/EGNOS?

Step-by-step instruction to enable WAAS/EGNOS:
1. Open GPS Viewer.
2. Scan com port of GM-210 and find correct com port.
3. Press "Open GPS" and you can see NMEA string output.
4. Check “WAAS/EGNOS” function to enable it.
Privacy Statement                                                     
© 2006 GPSWebShop (Canada) Incorporation.  All Right Reserved.


Products
Support
 
 
ecommerce provided by Yahoo! Small Business